After the phenomenal success of our DGX product, we listened to a great deal of feedback from our loyal userbase and have implimented some changes to the design to make the DGX perform even better than before – especially for Trinity boards.
После того как мы получили положительные отзывы от пользователей которые использовали DGX, мы решили привнести некоторые изменения в дизайн платы, а так же оптимизировали работу DGX платы- в частности на материнских платах Trinity.
DGX V1.1S change log:
- Added 70cm 24WG POST_OUT Wire
Добавлен 70 см 24 WG POST_OUT провод
- Added a ceramic cap option (Point C29) between D and GND (same as CR3 Pro) – included an optional 10pf ceramic cap
Добавлен керамический конденсатор (точка С29) между точкой D и землей (как у CR3 PRO)
- Added a selectable 5ohm and 10ohm resistor to post_out (simple solder jumpers 1 Closed: 10ohm, 2 Closed: 5ohm, 3 Closed: 0ohm Default)
Добавлены 5Ом и 10Ом резисторы POST_OUT (положение переключателей 1 закрыт: 10Ом, 2 закрыт: 5Ом, 3 закрыт: 0Ом по умолчанию)
- Added a a grounded IPEX socket (Point J1) for CPU_RST (10cm IPEX cable included)
- Larger solder pads and stronger vias (C D E F 5v GND)
- Removed JTAG pin header (Programming is not required – some users tried to program their DGX and damaged it)
- Optimized code for enhanced Trinity performance. DGX 1.1 would boot the worst Trinity we had in 30 seconds (v1.0 booted in 2 minutes)
- My preferred settings for Trinity were: D: 10cm IPEX to R4D4, C: 70cm 24AWG Wire , 10pf Cap Installed, 0ohm (Default)
- My preferred settings for Corona were: D: 10cm IPEX to C5R11, C: Default wire, No Cap Installed, 10ohm
- Remember that there may be fake DGX out there – it goes without saying that they are cheap garbage and you should stay away. Every official Xecuter product has a serial code – you should claim ownership of the code at serial.xecuter.com
DGX-V1_1S-4.jpg 97,46К
6 Количество загрузок:
DGX-V1_1S_fullkit.jpg 80,43К
6 Количество загрузок:
DGX v1.1S
Автор: InjutkinAG, 02 мар 2013 19:27
#1
OFFLINE
Отправлено 02 марта 2013 - 19:27
Количество пользователей, читающих эту тему: 0
0 пользователей, 0 гостей, 0 анонимных